Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Carburetors adapters, idle cut off, air bypass valve, choke elements and fuel pumps , spacers and filters for VW Volkswagen
Weber 40mm and 44mm idf dual carburetor kits with chrome gauze air filters, cross hex bar linkage, velocity stacks, aluminum manifolds for bus, buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle
Empi racing stripe jacket, Empi baseball cap hat, Empi classic posters
Made in USA 930 CV spline 300M race axles (sold in pairs)
Wide clamp from muffler to heater box $2.50
Billet aluminum buggy mount and brackets, gps mounts, off road registration sticker bracket, empi step plate for VW Volkswagen buggy, sandrails, bajas and sand cars
Spare tire tool box, engine dolly, oil pump puller, flywheel locks, valve guide installer, helping hand axle nut and gland nut tool for VW Volkswagen
Door panel clips, boot, stock style replacement arm rest, Empi door pulls, dash grab handle, wicker and bamboo under dash package trays for VW Volkswagen
Disc brake caliper with pads $55.00