Home > Cables & Replacement Chassis Panels > Accelerator Cable >

Clutch cable wing nut
131721349 Clutch cable wing nuts for VW Volkswagen Adjusting the clutch cable on a VW Volkswagen requires you to crawl under the car and turn the wing nut. It is located on the transmission cross shaft lever. When I adjust my clutch cable, I will clamp vi
 
List Price:$20.00
Our Price:$2.00
You save $18.00!


Product Code: 131721349
Qty:

Description
 
Adjusting the clutch cable on a VW Volkswagen requires you to crawl under the car and turn the wing nut. It is located on the transmission cross shaft lever. When I adjust my clutch cable, I will clamp visegrips to the cable so it won't spin when I am turning the wing nut. They say you want 1 inch of pedal play but I try to grab the cross shaft lever an tighten it until I feel the throw out bearing make contact and then back the nut off. Then I check the pedal play. If you tighten the wing nut too tight, the throw out bearing will never release from the pressure plate while the motor is running. This is a recipe for disaster. No play in the clutch cable adjustment will blow up the throw out bearing pressure plate. If you use a Kennedy pressure plate, it is a good idea to just replace the nut. The threads get pounded with heavy duty pressure plates. I always carry a new wing nut on my spare clutch cable.


Browse for more products in the same category as this item:

Cables & Replacement Chassis Panels > Accelerator Cable
Cables & Replacement Chassis Panels
Transmission & Clutch > Clutch Discs
Transmission & Clutch > Pressure Plates
Transmission & Clutch > Throw Out Bearings
Transmission & Clutch > Stock Clutch Kits
Transmission & Clutch > Performance Clutch Kits
Transmission & Clutch


Distributor caps, waterproof covers, backing plates, stainless covers, Bosch generators and starters, hard start relay kits for VW Volkswagen
Weber 40mm and 44mm idf deluxe dual carburetor kits with chrome or billet aluminum gauze air filters, cross hex bar linkage, velocity stacks, deluxe aluminum manifolds for bus, buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle
New Replacement brake kit for 1968 VW Volkswagen Beetle Bug with swing axle rear suspension new master cylinder, 4 wheel cylinders, 4 brake hoses , front and rear brake shoes, front and rear brake hardware kits. $199.00
Crankshaft flywheel dowel 8 dowel pin tool, gear puller, distributor drive puller, head assembly tool, spark plug tap for VW Volkswagen
Floor insulation sound absorber tar boards, metal floor panel quarter panel pans, stock rubber floor mats, Empi , New beetle and lady bug floor mats for VW Volkswagen Bug and Super Beetle