Home > Engine Kits & Parts > Fan hub nut and lock washer
	Our Price:$19.00 Product Code: 8898 Qty:

Description   This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the fan. You need 2mm (.080 inch) clearance so the fan will not rub the backing plates. This nut is to be torqued 40-47 ft lbs.

Related Products... Engine crankshaft degree aluminum power pulleys, sand seals and serpentine belts for VW Volkswagen Add Engine valve retainers, hardened lash caps, valve lock keepers, silicone bronze valve guides, push rod measuring tool, performance and chromoly push rods for VW Volkswagen Add Braided stainless steel line, high pressure and tempurature 3/8 and 1/2 inch oil hose, High capacity deep oil sumps, 1, 1.5, 3.5 quart for VW Volkswagen Add Engine crankshafts, chromoly and cast stock for VW Volkswagen Add Stock forged steel intake and exhaust valves, performance stainless steel valves, stock and high rev single and dual valve springs for VW Volkswagen Add

Browse for more products in the same category as this item: Engine Kits & Parts Electrical Components > Alternators 55, 75, 95 Amp Engine Kits & Parts > Pulleys & Belts Electrical Components > Generators & Voltage Regulators Engine Kits & Parts > Chrome Engine Goodies Electrical Components

Product price is not filled in. This product cannot be purchased.

Product price is not filled in. This product cannot be purchased.

Product price is not filled in. This product cannot be purchased.

	Exhaust gaskets, copper, metal, paper, steel exhaust flanges for VW Volkswagen
	Kadron rebuild kit $35.00
	SPECIAL ORDER VW AXLE SET
	Nylon spring loaded pushrod tubes (set of 8) $20.00
	D141R Disc Brake Pads $35.00
	VW LWRD BALLJOINT FRONT SWAYBAR, 7.500" DIAMETER
	165/15 Whitewall radial tires for VW Volkswagen $249.00
	New replacement upper ball joints for VW Volkswagen
	STUD, 14MM X 1.5 X 65MM LONG, EACH