Home > Engine Kits & Parts >

Fan hub nut and lock washer
Fan hub hardware kit for VW Volkswagen fan 8898.This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the
 
Our Price:$19.00


Product Code: 8898
Qty:

Description
 
This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the fan. You need 2mm (.080 inch) clearance so the fan will not rub the backing plates. This nut is to be torqued 40-47 ft lbs.


Browse for more products in the same category as this item:

Engine Kits & Parts
Electrical Components > Alternators 55, 75, 95 Amp
Engine Kits & Parts > Pulleys & Belts
Electrical Components > Generators & Voltage Regulators
Engine Kits & Parts > Chrome Engine Goodies
Electrical Components

Product price is not filled in. This product cannot be purchased.



Distributor caps, waterproof covers, backing plates, stainless covers, Bosch generators and starters, hard start relay kits for VW Volkswagen
VW FRONT BALLJOINT SWAYBAR, 7.500" DIAMETER
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
VW Bug IRS Rear Swaybar kit $129.00
Stock steel and performance chromoly valve retainers
Weber 40mm and 44mm idf deluxe dual carburetor kits with chrome or billet aluminum gauze air filters, cross hex bar linkage, velocity stacks, deluxe aluminum manifolds for bus, buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle
Shift rod bushings and hardware for VW Volkswagen
Empi engine high lift c channel bolt on aluminum valve covers, clip on and stainless steel, replacement valve cover gaskets for VW Volkswagen
EMPI Brosol/Solex/Kadron Dual 40mm and 44mm Carburetor kits with linkage, manifolds, chrome gauze air cleaners for Type 2 VW Volkswagen Bus 1700cc, 1800cc, 2000cc