Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


4 wheel brake hydraulic pedals, replacement tall and short square reservoirs, 5/8, 3/4 and 7/8, rebuild kits, clutch slaves for VW Volkswagen
Chrome crankshaft pulley bolt and washer
Transmission gasket set for type 1 VW Volkswagen beetle bug, early bus, type 3 square back, fastback, karmann ghia, thing $12.00
Empi dual 34mm epc carburetors kits with hex cross bar linkage, chrome gauze air cleaners, single and dual port aluminum manifolds for buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle ict
Engine valve retainers, hardened lash caps, valve lock keepers, silicone bronze valve guides, push rod measuring tool, performance and chromoly push rods for VW Volkswagen
Bentley Service Manual Fastback and Squareback 1968-1973 $79.00
U bends, bolt on and weld on stainless spark arrestors and racing mufflers for VW Volkswagen
Ratchet tie down, axle straps, tow straps and camlock tie downs for VW Volkswagen buggy, sandrails, bajas and sand cars
Fully polished 8 spoke alloy wheels with press on chrome center caps for VW Volkswagen 4 on 130 bolt pattern 15 x 5.5 $195.00