Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Replacement VW Volkswagen parts page 428
Dual port intake boot $5.00
Boxed 3x3 irs chromoly rear trailing arms, long travel torsion and polished stainless end plates for VW Volkswagen
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
Adjustable Aluminum Camshaft Gear Kit $67.00
Hydraulic pedal assembly, single and dual handle turning brakes for VW Volkswagen
Brass distributor drive crankshaft gear $32.00
Ratchet tie down, axle straps, tow straps and camlock tie downs for VW Volkswagen buggy, sandrails, bajas and sand cars