Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Brake fluid reservoir 1961-1966 Beetle $8.00
Billet aluminum buggy mount and brackets, gps mounts, off road registration sticker bracket, empi step plate for VW Volkswagen buggy, sandrails, bajas and sand cars
Stock left heavy duty heater box for 1963-1974 type 1 VW Volkswagen $189.00
4 wheel brake hydraulic pedals, replacement tall and short square reservoirs, 5/8, 3/4 and 7/8, rebuild kits, clutch slaves for VW Volkswagen
Fully polished 5 spoke rims with press on chrome wheel center caps and optional lugs, studs and washers. 5 on 205 bolt pattern. $195.00
Empi dual hpmx 40mm and 44mm carburetors kits with chrome velocity stacks, aluminum manifolds, chrome air cleaners with high flow gauze air filters, hex bar linkage for buggy, sandrails, baja Porsche and VW Volkswagen Type 2, 3 and 4
Billet and polished aluminum buggy dash panels, center consoles and switch boxes for VW Volkswagen
Stock muffler tip $11.00
Dual and single port end castings, air and intake manifold boots, clamps, gaskets for VW Volkswagen