Home > Cables & Replacement Chassis Panels > Accelerator Cable >

Clutch cable wing nut
131721349 Clutch cable wing nuts for VW Volkswagen Adjusting the clutch cable on a VW Volkswagen requires you to crawl under the car and turn the wing nut. It is located on the transmission cross shaft lever. When I adjust my clutch cable, I will clamp vi
 
List Price:$20.00
Our Price:$2.00
You save $18.00!


Product Code: 131721349
Qty:

Description
 
Adjusting the clutch cable on a VW Volkswagen requires you to crawl under the car and turn the wing nut. It is located on the transmission cross shaft lever. When I adjust my clutch cable, I will clamp visegrips to the cable so it won't spin when I am turning the wing nut. They say you want 1 inch of pedal play but I try to grab the cross shaft lever an tighten it until I feel the throw out bearing make contact and then back the nut off. Then I check the pedal play. If you tighten the wing nut too tight, the throw out bearing will never release from the pressure plate while the motor is running. This is a recipe for disaster. No play in the clutch cable adjustment will blow up the throw out bearing pressure plate. If you use a Kennedy pressure plate, it is a good idea to just replace the nut. The threads get pounded with heavy duty pressure plates. I always carry a new wing nut on my spare clutch cable.


Browse for more products in the same category as this item:

Cables & Replacement Chassis Panels > Accelerator Cable
Cables & Replacement Chassis Panels
Transmission & Clutch > Clutch Discs
Transmission & Clutch > Pressure Plates
Transmission & Clutch > Throw Out Bearings
Transmission & Clutch > Stock Clutch Kits
Transmission & Clutch > Performance Clutch Kits
Transmission & Clutch


Disc brake caliper with pads $55.00
Rack and pinions, billet and forged, A arm and beam cars, center load, end load, international and ford tie rods for VW Volkswagen
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
Polished stainless steel gas tanks, bracket hardware, fuel caps, remote filler necks and threaded weld bungs for VW Volkswagen buggy, sandrails and sand cars
EMPI Brosol/Solex/Kadron Dual 40mm and 44mm Carburetor kits with linkage, manifolds, chrome gauze air cleaners for Type 1 for Volkswagen
Buggy chrome offroad lights and covers, baja and led tail lights for VW Volkswagen
Oil baffle gasket for alternator and generator stands $1.00
Chromoly cut to length push rods Made In USA (set of 8) for VW Volkswagen $129.00
Weber 48MM IDA Dual type 1 carburetor kit with Hex linkage, manifolds, velocity stacks $1,779.00