Home > Engine Kits & Parts >

Fan hub nut and lock washer
Fan hub hardware kit for VW Volkswagen fan 8898.This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the
 
Our Price:$19.00


Product Code: 8898
Qty:

Description
 
This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the fan. You need 2mm (.080 inch) clearance so the fan will not rub the backing plates. This nut is to be torqued 40-47 ft lbs.


Browse for more products in the same category as this item:

Engine Kits & Parts
Electrical Components > Alternators 55, 75, 95 Amp
Engine Kits & Parts > Pulleys & Belts
Electrical Components > Generators & Voltage Regulators
Engine Kits & Parts > Chrome Engine Goodies
Electrical Components

Product price is not filled in. This product cannot be purchased.

Product price is not filled in. This product cannot be purchased.



Tuck-away Euro tuck dual exhaust for VW Volkswagen $235.00
Condenser installation, transmission drain plug, rear axle nut, cv bolt, oxygen sensor tool for VW Volkswagen
STUD, 14MM X 1.5 X 48MM LONG, WITH UNTHREADED TIP, EACH
Zoom tube $89.00
Empi race trim performance high and low back offroad racing suspension jeep CJ, Wrangler, Cherokee, seat mounts and adapters, drivers and passengers for autos, jeeps, trucks, boats and VW Volkswagen
Cylinder head stud hardware for VW Volkswagen engines 8mm and 10mm nuts and washers
Stainless Exh. Nut $0.50
Made in USA Sway-a-way swing axles (pair), 23 11/16" Long, 3" Shorter for VW Volkswagen Drag cars, Bug, Buggy, Manx $499.00
STUD, 14MM X 1.500 X 56MM LONG