Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Clutch cable wing nut $2.00
Empi Kadron Brosol Solex carburetor jets, throttle shafts and fuel fitting tees for VW Volkswagen
Crankshaft timing gear $32.00
Rebuilt stock 3 rivet camshaft $40.00
Replacement engine and motor parts, main bearings, standard and oversized thrust, cam bearings, standard and heavy duty double thrust, stock solex carburetor rebuild kit, starter bolt for VW Volkswagen
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
Empi engine high lift c channel bolt on aluminum valve covers, clip on and stainless steel, replacement valve cover gaskets for VW Volkswagen
Made in USA 930 CV spline 300M race axles (sold in pairs)
Distributor caps, waterproof covers, backing plates, stainless covers, Bosch generators and starters, hard start relay kits for VW Volkswagen