Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Copper exhaust nuts $0.50
1200-250-090 $65.00
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
Billet hydraulic pedal clutch slave, mounting accessories brackets for Type 1or 2 and Mendeola, rebuild kits for clutch and turning brakes, brake and clutch line kits for VW Volkswagen
Merged header sedan exhaust and phat boy mufflers for VW Volkswagen
3.5 Quart oil sump $224.00
German 1600 engine gasket set for VW Volkwagen air cooled motors $29.00
Replacement spiral lock circlips for 930 Axles, set of 4 $4.00
Empi T shirts, Type 1 bug convertible and ghia, Type 2 bus, Type 3 squareback, fastback, notchback, Empi inch pincher Tee shirts.