Home > Engine Kits & Parts >

Fan hub nut and lock washer
Fan hub hardware kit for VW Volkswagen fan 8898.This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the
 
Our Price:$19.00


Product Code: 8898
Qty:

Description
 
This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the fan. You need 2mm (.080 inch) clearance so the fan will not rub the backing plates. This nut is to be torqued 40-47 ft lbs.


Browse for more products in the same category as this item:

Engine Kits & Parts
Electrical Components > Alternators 55, 75, 95 Amp
Engine Kits & Parts > Pulleys & Belts
Electrical Components > Generators & Voltage Regulators
Engine Kits & Parts > Chrome Engine Goodies
Electrical Components

Product price is not filled in. This product cannot be purchased.



Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
STUD, 14MM X 1.5 X 54MM LONG, EACH
Standard Header Only 1600 cc Type 1 and Type 2 for VW Volkswagen $109.00
Bolt on performance 72 and 96 plate or 16 pass oil cooler kits with fans or thermostats for VW Volkswagen
Fresh Air Hose for VW fan shrouds
Empi HPMX dual 40mm and 44mm Type 1 carburetor kits with and without air cleaners for VW Volkswagen
Trimil bobcat offroad merged exhaust with quiet pack muffler (Made in USA) for VW Volkswagen Buggy
Emergency, throttle, clutch, heater, accelerator cable shorting and extending kits, universal and heavy duty cables with tube for VW Volkswagen
Bentley Workshop Manual Volkswagen Beetle 1200 1961-1965 $139.00