Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Weber 40mm and 44mm idf deluxe dual carburetor kits with chrome or billet aluminum gauze air filters, cross hex bar linkage, velocity stacks, deluxe aluminum manifolds for bus, buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle
Link pin rebuild kit
Performance 8 and 6 pass oil cooler kits with threaded or 1/2 inch hose barbs, filter and bypass adapters for VW Volkswagen
Empi carburetor conversion kit 32/36 E A M epc progressive for Jeep CJ, Cherokee, Carter, Rochester, Weber 2.1L, 4.2L, 2.5L engines
Replacement engine and motor parts, transmission cross shafts and bushing kits, clutch return springs, cable arms, engine gasket sets, cylinder head studs, fan hub, nut and washer hardware, mahle pistons and cylinders for VW Volkswagen