Home > Engine Kits & Parts >

Fan hub nut and lock washer
Fan hub hardware kit for VW Volkswagen fan 8898.This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the
 
Our Price:$19.00


Product Code: 8898
Qty:

Description
 
This the fan hub hardware needed to install a VW Volkswagen fan on the back of an alternator or generator. It is sometimes necessary to add generator shims to get clearance between the backing plates and the fan. You need 2mm (.080 inch) clearance so the fan will not rub the backing plates. This nut is to be torqued 40-47 ft lbs.


Browse for more products in the same category as this item:

Engine Kits & Parts
Electrical Components > Alternators 55, 75, 95 Amp
Engine Kits & Parts > Pulleys & Belts
Electrical Components > Generators & Voltage Regulators
Engine Kits & Parts > Chrome Engine Goodies
Electrical Components

Product price is not filled in. This product cannot be purchased.



Chrome swivel street stinger for VW Volkswagen headers $65.00
Front retractable 3 point seat belts (sold in pairs) for VW Volkswagen OEM style $199.00
Condenser installation, transmission drain plug, rear axle nut, cv bolt, oxygen sensor tool for VW Volkswagen
Empi and Facet solid state and rotary fuel pumps, fuel pressure regulators, mounts, brackets and fittings for VW Volkswagen
4 wheel brake hydraulic pedals, replacement tall and short square reservoirs, 5/8, 3/4 and 7/8, rebuild kits, clutch slaves for VW Volkswagen
Empi Kadron Brosol Solex carburetor jets, throttle shafts and dual port manifolds for VW Volkswagen
2 Tip GT Herbie hotdog muffler for VW Volkswagen $188.00
STUD, 14MM X 1.5 X 54MM LONG, EACH
88 X 69 Engine Rebuild Kit for VW Volkswagen 1679cc $649.00