Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Universal wire harness with fuse box for VW Volkswagen $92.00
Stock and 2 inch narrowed link pin front end beams for VW Volkswagen $449.00
113611723G Metal Brake Line 9.5" $5.00
Brake fluid reservoir 1961-1966 Beetle $8.00
Piston rings sets for VW Volkswagen $15.00
Ratchet tie down, axle straps, tow straps and camlock tie downs for VW Volkswagen buggy, sandrails, bajas and sand cars
Super beetle ball joints
Replacement engine & motor parts, carburetor gaskets, intake boots, barrel nuts and springs, throttle tubes, clutch discs and kits, pressure plates, throw out bearings, clips and guide tubes, cross shafts, release bearing operating shaft for VW Volkswagen
Replacement parts for hydraulic pedal assemblies, aluminum throttle pedals, pedal pads, boots, square top covers with screw on covers, roller pedal pivots, brackets, bolts, billet clutch slaves for VW Volkswagen