Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Wide clamp from muffler to heater box $2.50
Wheel adapters for VW Volkswagen to Ford, Chevy and Porsche lug bolt patterns
Replacement tie rods ends
Link pin rebuild kit
Weber 40mm and 44mm idf deluxe dual carburetor kits with chrome or billet aluminum gauze air filters, cross hex bar linkage, velocity stacks, deluxe aluminum manifolds for bus, buggy, sandrails, baja bug and VW Volkswagen Type 1, 2, 3, 4 Beetle
Billet and polished aluminum buggy dash panels, center consoles and switch boxes for VW Volkswagen
4 wheel brake hydraulic pedals, replacement tall and short square reservoirs, 5/8, 3/4 and 7/8, rebuild kits, clutch slaves for VW Volkswagen
Standard Header Only 1600 cc Type 1 and Type 2 for VW Volkswagen $109.00
Bug rear kick panels for VW Volkswagen $68.00