Home > Suspension Rear > Spring Plates, Bushings & Caps >

IRS Spring Plates for 21 3/4 torsion bars
IRS Spring Plates for 21 3/4 torsion bars
 


Product Code: 17-2672
Qty:

Description
 
These are for IRS rear adjustable spring plates for 21 3/4 torsion bars (early short torsion bars). Adjustable spring plates are built the same way as the standard plates, except that they are adjustable. These bolt-on spring plates allow about 1 inch of up or down adjustment by turning one screw on each on side. All adjustable spring plates use 1 7/8" outside and 2" inside urethane grommets


Browse for more products in the same category as this item:

Suspension Rear > Spring Plates, Bushings & Caps
Clearance
Suspension Rear


Chromoly combo spindles, ball joint and link pins front hubs, sand sealed wheel bearings for VW Volkswagen
Gravel guards, mud flaps, rain deflector for VW Volkswagen
87 X 69 Engine Rebuild Kit for VW Volkswagen 1641cc $599.00
Rack and pinions, billet and forged, A arm and beam cars, center load, end load, international and ford tie rods for VW Volkswagen
Carburetors adapters, idle cut off, air bypass valve, choke elements and fuel filters for VW Volkswagen
Black Replacement Hose for original Blue brake fluid hose 7mm $6.00
Stainless pushrod tubes $9.00
Weber tech manual $30.00
Replacement parts for hydraulic pedal assemblies, aluminum throttle pedals, pedal pads, boots, square top covers with screw on covers, roller pedal pivots, brackets, bolts, billet clutch slaves for VW Volkswagen