Empi hpmx and epc,Weber idf and ict carburetor floats, jet reamer and guage tools, fuel tee, block off plates, intake nuts. Carburetor Floats Same floats as supplied in EMPI's carburetors. These new upgraded plastic versions will also fit WEBER carburetor

Empi hpmx and epc,Weber idf and ict carburetor floats, jet reamer and guage tools, fuel tee, block off plates, intake nuts.

Carburetor Floats
Same floats as supplied in EMPI's carburetors. These new upgraded plastic versions will also fit WEBER carburetors.

43-6441 Replacement Float for EMPI 40/44 HPMX or 40/44 IDF, Each
43-6550 Replacement Float for EMPI EPC 32/36A, E, M, EPC 38, Each
43-6820 Replacement Float for EMPI EPC 34 or 34 ICT, Each

CARBURETOR TOOLS
These precision tools allow you to fine-tune your carburetors. The Jet Reamer Set features precision tapered reamers that cut to close tolerances. A selection of tapered reamers is packed in a protective plastic case. Know exactly what size you have cut your jets to with our Jet Size Gauges. Two size range gauges are available to fit all applications.

43-5715 Jet Reamer Kit
43-5716 Jet Gauge, .45mm - 1.50mm Range
43-5717 Jet Gauge, 1.50mm - 3.00mm Range

BRASS FUEL TEE'S
A must have for all dual carburetor applications. If you are using a plastic tee, now is the time to upgrade. All EMPI Dual Carb. Kits come with Brass Fuel Tee's.

43-5203 5/16" Barbed Brass Fuel Tee
43-4402 1/4" Barbed Brass Fuel Tee

HPMX OR IDF FUEL ENRICHMENT BLOCK-OFF PLATE
Use this zinc plated blockoff plate when you remove the "stock" choke assembly from IDF carburetors. Supplied with screws and washers. EMPI HPMX are supplied with a plate in place.

43-5709 HPMX or IDF Fuel Enrichment Block-Off Plate

HEAT RISER BLOCK-OFF PLATES
Covers heat riser flanges when intake heat riser is not used. A must when installing most dual carb kits. Includes gaskets.

3447 Heat Riser Block-Off Plate Kit
17-2824 Chrome Heat Riser Block-Off Plate Kit

UNI-LINK KIT
Allows you to adapt your linkage to fit any EPC 32/36F, DFV/DFEV Progressive Carb.

43-0602 Uni-Link Kit

EXTRA CLEARANCE NUTS
8mm 1.25 - thread with 11mm outside diameter nuts may be used on intake and exhaust for extra clearance. Made from Brass to resist rust and avoid seized threads.

43-6051 Brass 8mm-1.25 thread, 11mm Head, Int./Exh. Nuts, Set of 8
43-6051-B Bulk Brass 8mm-1.25 thread, 11mm Head, Int./Exh. Nuts, Bag of 100